Page 1 of 1

Could any one share some ideas on this?

Posted: Tue Jun 13, 2017 7:32 pm
by quaymat321234
Hi friends,

As the title describes, I met that problem when trying to enable libspeex in Cygwin.

I downloaded speex-1.2rc1.tar, run configure, make, make install and libs were installed in /usr/local/lib and header files installed in /usr/local/include/speex.

But when I ran configure --enable-libspeex to configure ffmpeg, an error was reported: ERROR: libspeex not found, I checked config.log and found "speex/speex.h: No such file or directory"

I've successfully enabled libtheora, libvpx in the same way, and their header files and lib files are in the same folder with those of libspeex. So I'm quite confused why speex.h couldn't be found.

libspeex could not be found?

Re: Could any one share some ideas on this?

Posted: Fri Jun 16, 2017 12:52 am
by Zeranoe
How did you configure FFmpeg? Providing the config.log would be helpful.