Could any one share some ideas on this?

Questions that occur when trying to compile FFmpeg.
Post Reply
quaymat321234
Posts: 1
Joined: Tue Jun 13, 2017 7:29 pm

Could any one share some ideas on this?

Post by quaymat321234 » Tue Jun 13, 2017 7:32 pm

Hi friends,

As the title describes, I met that problem when trying to enable libspeex in Cygwin.

I downloaded speex-1.2rc1.tar, run configure, make, make install and libs were installed in /usr/local/lib and header files installed in /usr/local/include/speex.

But when I ran configure --enable-libspeex to configure ffmpeg, an error was reported: ERROR: libspeex not found, I checked config.log and found "speex/speex.h: No such file or directory"

I've successfully enabled libtheora, libvpx in the same way, and their header files and lib files are in the same folder with those of libspeex. So I'm quite confused why speex.h couldn't be found.

libspeex could not be found?
Thanks
Qmat

User avatar
Zeranoe
Site Admin
Posts: 702
Joined: Sat May 07, 2011 7:12 pm
Contact:

Re: Could any one share some ideas on this?

Post by Zeranoe » Fri Jun 16, 2017 12:52 am

How did you configure FFmpeg? Providing the config.log would be helpful.

Post Reply